On our website, we would like to use the services of third-party providers who help us improve our promotional offerings (marketing), evaluate the use of our website (performance) and adapt the website to your preferences (functionality). We need your consent for the use of these services; you can always revoke this consent. You can find information about the services and the chance to reject them under “User-defined.” You can find additional information in our Data Protection Policy.

The Congress Programme

back to day overview

GEOFIT - ground source heat pump systems for energy efficient building retrofitting [30] Vortragssprache Englisch

In Europe, the building sector is responsible for 40% of the total energy consumption and represents about a third of Europe’s CO2 emissions. This is a huge socioeconomic and environmental problem, more if we con-sider that almost half of the EU buildings have boilers installed before 1992, with an efficiency rate of below 60%. Although energy renovation of existing buildings could help to achieve the EU climate and energy tar-gets, the refurbishment rate is currently below 1% and renewables are not widely used in the building sec-tor.
Within the H2020 project GEOFIT, easy-to-install, economical and enhanced geothermal systems for energy efficient building retrofitting are going to be implemented and demonstrated at five dedicated pilot sites across Europe - a historical building (ITA), a school (ESP), an indoor swimming pool (IRL), an office build-ing (FRA) and a single-family house (IRL).
The integration of ground systems with heating/cooling solutions and heat pumps to achieve maximum performance is a great challenge that demands a solution. In order to find the best solution for each pilot site with respect to increased supply temperatures compared to a new building, different heat pump config-urations are analyzed. As working fluid, a Low Global Warming Potential (GWP) refrigerant (e.g. R1234ze(E)) with a GWP smaller than 10 will be used. The system will include alternative cost-effective heat exchangers to be used with the Low GWP refrigerant like plate heat exchangers made of Aluminum instead of Copper.
One favorable heat pump configuration is a twin-cycle system which basically consists of two heat pumps with different condensation temperatures but with the same temperature on the source side. Alternatively, a single-stage configuration which uses a significantly larger condenser for enhanced subcooling is also ana-lyzed. Both systems allow a more efficient operation compared to state-of-the-art heat pump systems in the case of building retrofitting. So far, no residential ground source heat pump system exists where these tech-nologies (Low GWP, Aluminum heat exchangers) were combined. At the end of the demonstration phase in the GEOFIT project, the action will increase the commercial attractiveness of geothermal energy in combina-tion with ground source heat pumps and therefore increase the penetration of this renewable source in building retrofitting.

--- Date: 23.10.2019 Time: 14:10 - 14:35 Location: Hall Brüssel, NCC Mitte

Main speaker

Dr. Michael Lauermann

Dr. Michael Lauermann

Research Engineer / AIT Austrian Institute of Technology


The selected entry has been placed in your favourites!

If you register you can save your favourites permanently and access all entries even when underway – via laptop or tablet.

Hier registrieren Sie sich, um Daten des Rahmenprogramms dauerhaft zu speichern.

Register now

Your advantages at a glance:

  • Advantage Save your favourites permanently. Use the instant access – mobile too, anytime and anywhere – incl. memo function.
  • Advantage The optional newsletter gives you regular up-to-date information about new exhibitors and products – matched to your interests.
  • Advantage Call up your favourites mobile too! Simply log in and access them at anytime.